 |
| MODEL |
LGK-160 |
| Input power voltage (V) |
AC220 ±15% (1 Ph) |
| Input power capacity (KVA) |
32.5 |
| Input voltage frequency (Hz) |
50 |
| No load voltage (V) |
400 |
| Output current (A) GTAW / TIG |
30-160 |
| Arc ignition |
HF |
| Output voltage (V) |
144 |
| Duty cycle (%) |
60 |
| Efficiency (%) |
Nil |
| Insulation class |
F |
| Dimensions (mm) |
670 x 335 x 633 |
| Weight (kg) |
57 |
| Protection class |
IP21S |
| Genuine cut (mm) |
38 |
| |
| OPTIONALS |
|
AVAILABLE ACCESSORY |
| - 3 Hours Power Air Compressor |
|
- A-140 Plasma Torch Complete
With Sleeve 6m Pressure
- Regulator With Filter
- Earth clamp With Cable STD
|
|
| |
| CHARACTERISTIC |
- Less consumption of electricity, light weight,
high frequency, built in protective circuit to
prevent over heat, over current, over or under
voltage and ECONIMICAL.
|
- Feed-back circuit is controlled by advanced IGBT
technology, stable output.
|
- Cutting current can be adjusted
continuously from 20Amps to Max
current, be able to meet the demands
of different materials, thickness and
cutting speed.
|
- Non-contact arc starting mode without HF, little interference to the nearby electronic equipment.
|
- Applicable to cut carbon steel, stainless steel, galvanized steel, copper and aluminium, etc. With protection functions of short phase, over or low voltage, overheat or low air pressure.
|
|
|
|
|
| |
 |
|
