 |
| MODEL |
CUT-60 |
| Input power voltage (V) |
AC220 ±15% (1 Ph) |
| Input power capacity (KVA) |
7.1 |
| Input voltage frequency (Hz) |
50/60 |
| No load voltage (V) |
240 |
| Output current (A) GTAW / TIG |
20-55 |
| Arc ignition |
Nil |
| Output voltage (V) |
102 |
| Duty cycle (%) |
60 |
| Efficiency (%) |
85 |
| Insulation class |
F |
| Weight (kg) |
21 |
| Dimensions (mm) |
540 x 215 x 360 |
| Protection class |
IP21S |
| Genuine cut (mm) |
9 |
| |
| OPTIONALS |
|
AVAILABLE ACCESSORY |
| - 3 Hours Power Air Compressor |
|
- SP-50 Plasma Torch Complete
With Sleeve 6m Pressure
Regulator With Filter
Earth clamp With Cable STD |
|
| |
| CHARACTERISTIC |
- Less consumption of electricity, light weight,
high frequency, built in protective circuit to
prevent over heat, over current, over or under
voltage and ECONIMICAL.
|
- Feed-back circuit is controlled by advanced IGBT
technology, stable output.
|
- Cutting current can be adjusted
continuously from 20Amps to Max
current, be able to meet the demands
of different materials, thickness and
cutting speed.
|
- Non-contact arc starting mode without HF, little interference to the nearby electronic equipment. |
- Applicable to cut carbon steel, stainless steel, galvanized steel, copper and aluminium, etc. With
protection functions of short phase, over or low
voltage, overheat or low air pressure.
|
|
|
|
|
| |
 |
|
