 |
| MODEL |
CUT-40 |
| Input power voltage (V) |
AC220 ±15% (1 Ph) |
| Input power capacity (KVA) |
4.8 |
| Input voltage frequency (Hz) |
50/60 |
| No load voltage (V) |
230 |
| Output current (A) |
20-40 |
| Arc ignition |
Nil |
| Output voltage (V) |
96 |
| Duty cycle (%) |
60 |
| Efficiency (%) |
85 |
| Insulation class |
B |
| Weight (kg) |
8 |
| Dimensions (mm) |
371x155x295 |
| Protection class |
IP21S |
| Post flow time (SEC) |
Nil |
| Genuine cut (mm) |
6 |
| OPTIONALS |
|
AVAILABLE ACCESSORY |
| - 3 Hourse Power Air Compressor |
|
- PT-31 Plasma Torch Complete With Sleeve
6m Pressure
- Regulator With Filter Earth clamp With Cable STD |
| CHARACTERISTIC |
- Less consumption of electricity, light weight, high frequency, built in protective circuit to prevent over heat, over current, over or under voltage and ECONIMICAL.
|
- Feed-back circuit is controlled by advanced IGBT technology, stable output.
|
- Cutting current can be adjusted continuously from 20Amps to Max current, be able to meet the demands of different materials, thickness and cutting speed.
|
- Non-contact arc starting mode without HF, little
interference to the nearby electronic equipment. |
- Applicable to cut carbon steel, stainless steel, galvanized steel, copper and aluminium, etc. With protection functions of short phase, over or low voltage, overheat or low air pressure.
|
|
|
|
| |
 |
|
